Shopping Cart

Your cart is empty.

Your cart is empty.

2PCS Hydraulic Steering Bleed Kit,Sea star Hydraulic Steering Filler Bleed Kit Use for Fill Hydraulic Steering Fuel,Hydraulic Steering Kit/Fill Kit Compatible with All Outboard Sterndrive

5.0 Write Review
Free shipping on orders over $29.99

$25.99

$ 13 .99 $13.99

In Stock

About this item

  • Rust free：All of the metal within the bleed kit is brass and stainless steel preventing rust. Corrosion Resistant, ensure everlasting quality even in marine applications.
  • Easy to use：The quick connect fittings make filling or bleeding hydraulics system an effortless task by eliminating the need to screw in both threaded ends in different directions.
  • Compatibility：Universal for Hydraulic Steering Systems. Work with most outboard, inboard/outboard, and inboard hydraulic steering kits including Seastar.
  • Features：Threaded brass fittings will not cross-thread, ensuring that the hydraulic steering kit will not leak or get dirty when bleeding.
  • Effective Fluid Pumping: The discharge fitting can be positioned upward when pumping fluid with the rudder pump. This design allows air to escape from the cylinder, ensuring efficient and effective fluid pumping.


Specification:
Material: Polyurethane, Stainless Steel
Color: Gold Tone, Clear
Bridge Tube Inner Dia. :9mm/0.35 inch
Bridge Tube Length: 47.5cm/18.7 inch
Bridge Tube Outer Dia. : 10mm/0.39 inch
Filler Hose Thread Size: 1/4 NPT
Filler Hose Hole Dia. : 8mm/0.31 inch
Filler Hose Length: 44cm/17.32 inch
Filler Hose with Screw Cap Dia.: 26mm/1.02 inch
Filler Hose with Screw Cap Outer Dia. : 12mm/0.47 inch

Basic Instructions:
1. Attach bottle to helm reservoir (do not pierce bottle)(do not let bottle run empty).
2. Connect bridge tube to fittings on steering cylinder and loosen fittings.
3. Use helm to pump fluid through system by turning the wheel in one direction. Air bubbles will be pushed to the reservoir at the helm.
4. Manually swing the outboard through full articulation to relieve trapped air.
5. Note: Orientating fittings up while pumping fluid with helm will allow air to escape cylinder.
6. Repeat 3-4 times necessary until no air is visible in bridge tube.
7. Tighten fittings before removing bridge tube.

Package Included:
1 x Bridge Tube
1 x Filler Hose with Screw Cap (With 11/20 inch straight pipe thread fitting)