Your cart is empty.
Your cart is empty.TEN Factory: Precision Forged for Quality, Strength and Performance - All TEN Factory axles feature a 10-year replacement warranty! Front axles and two axle rear kits are black oxide coated. TEN Factory is the brand you can trust for the highest-quality engineered axle shafts and replacement kits. Built with the toughest materials, the wear-resistance of forged steel is heat-treated to produce durable axle shafts for your Jeep, car or truck. Buy with confidence knowing that the latest technologies in metallurgy, heat treating and CNC machining have produced an axle you can count on in the most difficult conditions.
Ahiwela
Reviewed in the United States on January 6, 2022
According to TenFactory the MG22157 are 4140 Chromoly shafts. I thought folks would want to know that since its not in the description. Everything fit perfectly in my 2013 JKUR. It’s only been about a month since install but so far so good!
Customer
Reviewed in the United States on December 3, 2020
These are fantastic. Very strong. 2 bolt pattern holes, you choose the pattern and push the bolt studs in. For JK's, the pattern will be the inner holes, not the outer.I didn't have a press, but bought one at harbor freight and everything went on smoothly. A shop will likely try to charge you that amount to set them up and install them! There is a picture in the kit which shows you the order. Press on the tone ring, then slide on the retaining plate, then the seal. Then you put on the bearing paying attention to the picture for orientation, slide the collar on, and press it all down on the collar. If you are worried about the DIY aspect of this it's very easy. Very strong axles to support larger tires!
Tom
Reviewed in the United States on March 21, 2019
I can't say if they are good or bad because I never opened the box. I could not find anywhere where they are made, so I called the company and found out they are made in India. I refuse to put global products on one of the few vehicles that is still mostly American made. Nuff said...
gchumba
Reviewed in the United States on December 22, 2019
This fit my Jeep jk. My Jeep is not a rubicon, but I still have a rear locking diff. 32 spline axle is what it uses. If you do not have a shop press at home, find a local shop that does... I paid $30 for the bearings to be put on. Everything installed back on without any problems.
Recommended Products
$149.19
$ 67 .99 $67.99
$140.95
$ 63 .99 $63.99
$148.95
$ 67 .99 $67.99