Your cart is empty.
Your cart is empty.Product Description
Pure Copper Wire/PVC Insulated Jacket
Battery Power Cables 2/4 AWG
Voltage Rating :600 Volts Lugs Terminals: solid copperwith a tin plating cover
Operational TemperatureRange: -15°C to +105°C
kneebuster
Reviewed in the United States on August 18, 2024
I got these to connect up a pair of batteries. They may be overkill on size, but better safe than sorry. They are very flexible and easy to run between the batteries.
J. T.
Reviewed in the United States on July 21, 2024
Overall these cables are a decent quality. I would have preferred a slightly more heavy duty crimp connector. The good for a light duty battery or solar use.
Customer
Reviewed in the United States on June 6, 2024
I got these for an at-home solar system and they work great. They’re easy to set up and a good size for connecting batteries. Ready made so you don’t need to install the ends yourself.
J
Reviewed in the United States on June 1, 2024
They seem like good quality cables, the holes in the terminals are a good bit larger than 3/8th so if you want to put them on a smaller battery post they might not fit well. They are pretty flexible which is nice. I haven't run a ton of amps through them to know if they will get hot with a lot of current but they seem well made so I don't think that will be an issue. The insulation says "welding wire" on it, not sure why it says that as they are advertised as battery or power inverter cables.
Warren W Glen
Reviewed in the United States on June 1, 2024
Initial look showed everything looked good. Heavy cable, hex crimps.Closer look showed that some of the crimps weren't as "crisp" as some of my other cables.When I attempted to twist the crimped ends, I could feel some "give" to the connections and it felt like there was a small definite "snap" as the end moved. Once it "snapped", it would not exhibit any more give until I twisted it back and there was another snap as it moved. Three of the crimped ends exhibited this behavior.I will cut off the heatsink and see if I can observe what is going on before I cut the ends off and crimp on new ends.
Engineer dude
Reviewed in the United States on May 31, 2024
I needed a few short, heavy cables for my boat to jumper between batter, main disconnect switch, breaker, etc. and this set fills the bill. The cables measure JUST under 24" from center of hole to center of hole, but just over 24" overall. Each one is labeled with the gauge, length, and lug hole diameter for each end. The raw cable itself also has markings confirming the proper gauge from its manufacturing.Overall, a nice product -- happy to recommend this one.
midwest75
Reviewed in the United States on May 29, 2024
I ordered these to replace 2 cables on my bay boat that were compromised. In my opinion, they will work as spare cables. The cables seem to be adequate however, they do not have copper ends and the ends are not heavy-duty. The cables are 12" from the c/c of the terminal ends. Again, I plan to keep these on my boat for spare cables and get a couple of cables that have heavy-duty ends.
Jokerman
Reviewed in the United States on October 9, 2024
Great value for the price. Quality build of materials. Fast delivery. Caution make sure the bolt size is correct.
Recommended Products
$37.99
$ 16 .99 $16.99