Shopping Cart

Your cart is empty.

Your cart is empty.

Chenyang 2Pcs TF Micro SD Card Male Extender to SD Card Female Extension Adapter PCBA SD/SDHC/SDXC UHS-III UHS-3 UHS-2

Free shipping on orders over $29.99

$15.88

$ 7 .99 $7.99

In Stock

1.Color:Black Tf Male To Female


About this item

  • Support UHS-I (full speed Up to 104MB/Sec) (High speed 52MB/Sec).
  • Support UHS-II UHS-III (full speed Up To 321MB/Sec ).
  • Application: GPS , ROCK Pi 4 raspberry Pi SCM development board,
  • Machine equipment and other needs to extend the SD card to the use UHS-II Extender Adapter.
  • Test: UHS-II SD card 270MB/s , test speed 250MB/s.


2pcs TF Micro SD Male Extender to SD Card Female Extension Adapter PCBA SD/SDHC/SDXC UHS-III UHS-3.
The package included one TF-TF extender and one TF-SD extender.
Support UHS-I (full speed Up to 104MB/Sec) (High speed 52MB/Sec).
Support UHS-II UHS-III (full speed Up To 321MB/Sec ).
Application: GPS , ROCK Pi 4 raspberry Pi SCM development board,
Machine equipment and other needs to extend the SD card to the use UHS-II Extender Adapter.
Test: UHS-II SD card 270MB/s , test speed 250MB/s.
Connector: TF Male to TF/SD Female.


Jeanck
Reviewed in France on February 22, 2025
bon adaptateur pour connecter une carte SDHC sur PC et tablette
カスタマー
Reviewed in Japan on February 20, 2025
ドラレコ用に購入、ドラレコの挿入フックに引っかかる前に、接続端子にぶつかってしまい、奥まで入らず全く使えません。
Qcode
Reviewed in Japan on April 25, 2025
指先が器用ではないので、この商品は、microSDカードの抜き差しに重宝しています。基盤が軟らかく剥き出しのところはイマイチなのですが、性能には問題はないので減点していません。指先不器用な方は、一個持っていると便利です。
GTS
Reviewed in the United States on September 3, 2024
So far no issues. Works fine.Nice to be able to access hard to reach SD cards.
Kindleユーザー
Reviewed in Japan on June 15, 2024
レーダー探知機のmicroSDをWiFi機能付SDに変換するために購入しました。ところが、現在の探知機は既にSDカードになっていたため、使用することがなく、動作確認に留まりました。きっと何かの機会に役立つものと思います。
br2012
Reviewed in Germany on September 22, 2023
endlich eine Lösung um einfach auf Microsd Karten zuzugreifen. Läuft super !
RVW
Reviewed in the United States on December 11, 2023
In the testing of a device I lost use of some because the socket for SD TF cards is not super reliable and can be damaged from normal use and is non-repairable. This has save me $! Also, off the subject of you swap micro sd cards into pcs and macs you can experience failure of the cards, not working in either one. Put it back in a pc and format it and it will work once again
Romie Searle
Reviewed in the United States on January 10, 2023
I use this thing hard . I bought 3 of them my only gripe is that the thin edge where the small ss card goes in is broken on 2 of them . If I am very careful I can still insert the card and sometimes on my raspberry pi400 they don’t click in but most of the time they still work. I just purchased 2 of someone else’s adapters and I will see how they work…
aaehlmopstu
Reviewed in the United States on March 21, 2022
the big thing here is insertion into SD card port. the length of the adapter makes it a lot easier to insert. works well for my purpose. good luck.
Netham
Reviewed in the United States on July 24, 2021
I had a Raspberry Pi enclosed in a 3D-printed case, this let me extend the SD card of it so I could cut a hole in the side and have an externally accessible SD card still.
teknogeek1300
Reviewed in the United States on March 6, 2019
I use this for a dash camera in my car. This doesn't "click" inside the camera as well as the cards do, and required me to use superglue and a piece of properly cut paper to make it thick enough to stay in my camera. Other than that, it does it's job. My was particularly important because it hangs from the bottom of the camera, and vibrated.
J. Layne
Reviewed in the United States on October 11, 2018
Had to buy an open case with my Odroid C2 since there aren't a lot of options for cases. One of the problems was the case was it made the micro sd card hard to get to and nearly impossible to removed with out small pliers. This little miracle worker was able to extend out my card slot so its easily accessible now. Didn't notice any performance issues or anything different with the Android OS loaded on to the card. Very satisfied with the purchase.
VG Wisconsin
Reviewed in the United States on December 2, 2017
I used this to extend my Raspberry Pi Model B slot so I could use a custom case. After many months of use, it's still sturdy. The card still fits in tight. And most importantly - I can easily remove the card without removing the converter. I was debating on gluing it in but I didn't have to. The way it's made, when you remove a card from it, your thumb or index finger will be on the back side of the converter, so it braces it into the socket. Not putting the slot on the edge of the converter card was a good design idea.
Recommended Products

$97.30

$ 41 .99 $41.99

4.3
Select Option

$17.75

$ 8 .99 $8.99

4.8
Select Option