Your cart is empty.
Your cart is empty.Holds harmonic balancer in place when removing or installing center bolt or Ford Taurus pulley extension. Perfect for tight clearance. No need to lock flywheel. Won't warp balancer. Services 2.5 And 3.0L V6 Duratec engines from mid 1990’s to 2007, including Ford Contour And Taurus, Mercury Sable, Cougar And Mystique, Lincoln LS, Jaguar S-Type, and Mazda Tribute. 5/16” thick steel base with ½” square drive. Can use 8mm x 1.25 bolt to hold tool balancer for some application. California Prop 65 - Warning, This product contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm.
RaulS
Reviewed in the United States on December 12, 2024
I saw a post somewhere that someone used this to remove the harmonic balancer on a Mercedes M112 engine, and the place to place the 1/2 inch breaker bar stripped so it was not a good experience for me. I'll give it 3 stars since it was not built specifically for my engine so its on me that it did not fit. But the stripping of the tool that is supposed to resist over 100 ft lbs of torque on the bolt is not on me.
カスタマー
Reviewed in Japan on November 28, 2024
海外の情報でメルセデスM112、M113にも使えることを聞いて購入。専用工具が3万円以上なのでDIY派のは良いかも。ただし社外プーリーの場合ちょっと外周部を削るなどの加工が必要。
Dale Allen
Reviewed in the United States on September 10, 2023
Bought for my Mercedes ML320. I read that it might work. The product is solid of great quality, and initially, it looked like it would fit, however, my Harmonic Balancer is tapered on the inside so this slipped right out. The dowels that stick out are not long enough to catch on my vehicle. Overall I think it would have worked if it could have stayed in place. No ill will toward the seller but I had to return this..
jennifer walker
Reviewed in the United States on August 19, 2023
It works as expected on the car.
Jason
Reviewed in the United States on May 31, 2023
The box says for Ford/Mazda, but works perfectly for some mercedes engines too. Was able to replace my front main seal without needing to remove my radiator fan. Held up nicely, fit was perfect and doesn't weigh alot either.
Mongler
Reviewed in the United States on October 21, 2023
I had to use a hammer to gently tap it into place. Worked great.Used an ARP bolt at 100ftlbsThis was on a triton 2v but basically all ford harmonic balancers are the same.Very good tool I'll be able to use many times.
Chris Osiecki
Reviewed in the United States on July 3, 2021
Was supposed to fit on my vehicle, but it did not. Will be returning.
Jessica Garza
Reviewed in the United States on July 29, 2019
Makes it easy to hold crank and torque bolt on ecoboost crankshaft
Jason
Reviewed in the United States on January 10, 2019
I was finishing a complete timing chain replacement on a 2013 Ford F-150 3.5l turbo Ecoboost motor and I took a chance on this tool. Worked as advertised, held the pulley in place while torquing the crank pulley bolt.
Recommended Products
$66.49
$ 25 .99 $25.99
$68.98
$ 33 .99 $33.99