Your cart is empty.
Your cart is empty.Product Description
Please check the application before you place the order to make sure you get the right part. Feel free to contact us via Amazon Messaging with any application issues
brand_description
Formula Auto Parts
HRH
Reviewed in the United States on April 5, 2025
*Update: the sensor did not work after the install, there is 0 reading from the sensor. The OEM at minimum moved the gauge* 2000 7.3L. The extruding tab opposite of the holding tab did not line up with the OEM slot on the plug; the top tab had to be shaved off with a razor for this item to fit. The fit is very tight and takes some force to connect, but the holding/release tab functions as intended. The red thread sealer left shavings at the bottom of the port after installation.
Parvez
Reviewed in the United States on June 29, 2024
I had issues with my 1998 F150 4.2 truck, it doesn't show any code with scanner, but scanner live data shows engine coolant temperature is negative, and I can't start truck right after first start (or warm engine), truck running very rough. On cluster temperature gauge showing good temp reading. Problem was this sensor which send the signal to PCM. After replacing this sensor truck running well.
n257jy
Reviewed in the United States on May 6, 2023
Connector fit is very tight. OEM plug is much too tight and barely could be inserted.Design needs improvement. Otherwise works well.
Ese Cesar
Reviewed in the United States on May 19, 2023
Connector is slightly different. It connect & clicks but doesn’t read the gauge inside the dash so I used the old oem & keep searching for the right one.Update: found it FORD SW-5130
Jlp
Reviewed in Canada on November 13, 2023
Plug does not fit over 2003 Ford Ranger 3.0 sensor. Company should read its own reviews and short it out or remove vehicle lists. Don't waste your money
Christopher
Reviewed in the United States on September 11, 2022
Fit my 2001 7.3 f250 and computer recognized it.
Clint
Reviewed in Canada on June 19, 2022
Wrong part for my 07 Ford Explorer connection doesn’t match and the threads on the sensor head are way too big for the hole don’t buy waste of my time and money junk
james t hixson jr
Reviewed in the United States on May 22, 2022
Check the electrical connector before installing. The fit was too tight but after filing down the plastic connector and addingA small amount of silicone lubricant The electrical connector worked fine
EricT
Reviewed in the United States on May 12, 2022
after leaving a 1 star review I realized this is a sensor not a sender. They are separate. This tells your ECU the temp of your engine NOT YOUR GAUGE ON DASHBOARD. do your research, I guarantee half of these bad reviews are people just like me who put it in the wrong place. They are practically identical.
J.W
Reviewed in Canada on September 25, 2021
Good value , quick delivery , and identical to OME Sensor that was on my mustang .
Monday. Customer.
Reviewed in Canada on July 13, 2021
These did not fit my stock 1996 Mustang Pigtails - AND THAT'S WHEN IT STARTS TO GET EXPENSIVE...I HAVE HAD TO GO TO ANOTHER SITE. New pigtails, and two new - ones that work - temp sensors.These did not fit my stock 1996 Mustang.
Israel Juarez
Reviewed in the United States on December 13, 2021
I would have given 5 stars however when plugging in it was a bit snug. OEM tends to be easier fit. Regardless it works well on my 1999 Mercury Sable DOHC V6.
Recommended Products
$43.59
$ 21 .99 $21.99