Your cart is empty.
Your cart is empty.Fit for 1/18 scale crawlers like Axial SCX24 Gladiator, Bronco, C10, Deadbolt, AX24, TRX4M, and FCX24. No modifications needed—direct bolt-on installation in minutes
John
Reviewed in the United States on March 30, 2025
These wheel/tires come ready to assemble. Due to the vey small screws and alighning the front and rear beads these tires ca be worked on by children but under adult supervision. The final result is a set of soft rubber tires with substantial grip on both asphalt and dirt surfaces. The rims are finely machined and fit together with an air tight seal on the rim surface producing a tire that appears to be air filled. The air filled like characteristic produces a resilient tire with outstanding flex and grip. Fantastic for 1/18 RC use.
Skree
Reviewed in the United States on March 10, 2025
These wheels come with the foams and tires pre-mounted. All I had to do was install the screws. All the screw holes were aligned front and back so I didn't have to mess with them at all which was nice. A 1.3mm hex key and a 5mm wheel nut wrench is included as well as some extra screws.The aluminum wheels appear to be good quality. I didn't find any imperfections or blemishes on any of them. I thick they look great on my black K5 Blazer FCX24. The tires are soft and sticky. I have these same tires that came with a different set of wheels but these ones feel like a different compound. They are a tad bit softer and a lot stickier. There is photo on the listing that shows these tires measured at 56mm. They are actually 57mm. I do mostly trailing with some light crawling and these tires perform well. If your strictly crawling these probably aren't the best but they're not bad either.I initially had some trouble getting these wheels on my FCX24. I couldn't get the wheel nuts fully tightened down because the screws were getting in the way. I had ground down the wheel wrench that came with the FCX24 to get the nuts on a different set of wheels I have but even with that there isn't enough room. I found that Injora has a set of extended wheel nut to remedy this problem. I could only find them on Injora's website but I didn't want to wait for the shipping from China. I found the same exact ones here on Amazon. They are a little bit more expensive but you get 25 instead of 4 and they came to me in two days. Search "uxcell M3 x 5mm Female Threaded Brass Hex Standoff Pillar Spacer Nuts 25pcs" to find them. They are a bit taller than the stock FCX24 wheel nuts and they are only 5mm wide instead of 5.5mm so I was able to use the wheel wrench that came with this set. The only thing is, you'll probably want to add a bit of thread lock to keep them from coming loose because they aren't nylocs.
Recommended Products
