Your cart is empty.
Your cart is empty.Headlight
Jim
Reviewed in the United States on May 23, 2021
Just finished replacing my AC belt and the tool worked like a charm! Saved $100 by using this.
nick quinteros
Reviewed in the United States on November 11, 2016
It did the job and got my belt onto the pulley. only con was that mine came with chipped paint and the bolt was slightly warped and was just a bit difficult to tighten.
Marcus A.
Reviewed in the United States on October 14, 2015
Doesn't fit my 2006 Mazda 3 2.0, it's very small. It seems well built though
Brian Tanguay
Reviewed in the United States on April 8, 2014
Used with Dayco E050265 Serpentine Belt for a 2007 Mazda 3 i Touring sedan to install that AC compressor belt while I was changing the Serpentine belt. Unfortunately, Mazda put the AC belt in the way of the serpentine belt so removal was required. This tool did not work to remove the ac belt that was currently on the pulleys. The reason being, it would tilt so the belt would not be angled off the pully when cranking the driveshaft around. If the tongue was a little longer and went across the pulley to both sides, it would be perfect for removal.on the plus side, it definetly helped installing the belt as it allowed it to just slip on. On the mazda 3, the screw shown in the picture is not used and this is told on the shipping order that you get.Hope this helps other mazda 3 owners!
Recommended Products
