Your cart is empty.
Your cart is empty.This windshield wiper arm is designed to match the fit and function of the original arm on specified vehicles, and is engineered for durability and reliable performance. This part is compatible with the following vehicles. Before purchasing, enter your vehicle trim in the garage tool to confirm fitment. [Buick Rendezvous: 2002, 2003, 2004, 2005, 2006, 2007] - [Chevrolet Venture: 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005] - [Oldsmobile Silhouette: 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004] - [Pontiac Aztek: 2004, 2005] - [Pontiac Montana: 1999, 2000, 2001, 2002, 2003, 2004, 2005] - [Pontiac Trans Sport: 1997, 1998]
Hobo
Reviewed in the United States on October 29, 2024
3" too short...could not use it.
Whit
Reviewed in the United States on May 25, 2023
Arrived quickly, Good product, great value, easy install had no problem what so ever.
Carla Davis
Reviewed in the United States on November 3, 2023
Was exceptable
E. Fuller
Reviewed in the United States on July 18, 2022
Works great on ‘02 Pontiac Montana.
turnabout
Reviewed in the United States on November 18, 2021
This replacement wiper arm is a perfect fit and was easily installed. Although the product is made in PRC, quality looks to be quite good.I also replaced the wiper blade with a Rain-X Latitude which attached perfectly.
Customer
Reviewed in the United States on January 18, 2020
Fits like it should
B. Swanson
Reviewed in the United States on March 8, 2019
I’ve had two Buick Rendezvous. The rear wiper has never consistently worked on either. I’ve used lots of different oils to try to get the arm to move easy enough so the blade keeps in contact with the glass. Had I known how much better this arm was than the OEM, I would have replaced it years ago. The spring on this has a lot more force. To replace pivot the dust cap from over the nut. Remove the 13 mm but. I used a three jaw gear puller to remove the arm. Place the new one on and tighten up the nut.
Robert Dickson
Reviewed in the United States on June 24, 2013
I replaced the rear window wiper arm at the same time as the wiper motor. Looks great and works great. The old one was weathered and starting to rust. The new wiper arm didn't have a splined fitting to go over the spindle, yet the old one did. I installed it anyways assuming a friction fit would work with a couple good taps of the hammer. It's been working fine so far. Perhaps the friction fit saves the gears in the motor if for some reason the wiper is turned on but it physically can't move on the outside due to being frozen in place or weighted down with snow.
Recommended Products
$42.88
$ 20 .99 $20.99
$57.95
$ 28 .99 $28.99