Shopping Cart

Your cart is empty.

Your cart is empty.

Dorman 674-221 Passenger Side Exhaust Manifold Kit - Includes Required Gaskets and Hardware Compatible with Select Ford Models

4.6 (3) Write Review
Free shipping on orders over $29.99

$77.89

$ 34 .99 $34.99

In Stock
  • Ideal replacement - this exhaust manifold was precision-engineered and durably manufactured to match the fit and function of the stock manifold on specified vehicles
  • Reliable construction - durable materials resist warping, cracking and leaking for long-lasting performance
  • Complete repair - includes all necessary gaskets and downpipe hardware
  • Trustworthy design - built by industry leader in aftermarket manifolds
  • Ensure fit - to make sure this part fits your exact vehicle, input your make, model and trim level into the garage tool


This exhaust manifold was precision-engineered and durably manufactured to match the fit and function of the original manifold on specified vehicles. It includes all necessary gaskets and downpipe hardware for a complete repair. This part is compatible with the following vehicles. Before purchasing, enter your vehicle trim in the garage tool to confirm fitment. [Ford Bronco II: 1986, 1987, 1988, 1989, 1990] - [Ford Ranger: 1986, 1987, 1988, 1989, 1990, 1991, 1992]


chris
Reviewed in the United States on August 30, 2018
Everything fit properly, except for the problems with the block it when on easily and still working so far
M.koenig
Reviewed in the United States on July 18, 2018
Fit great on a 1988 ranger just keep in mind this manifold is thicker than stock I had to get all new bolts at least a 1/2" longer
Customer
Reviewed in the United States on July 24, 2014
Was purchased for a '88 Bronco II. Overall, quality is poor, as it is a rough cheap cast. I figured it would do as I don't need header-performance out of the little 2.9L V6. Unfortunately it isn't to spec in dimensions. From the rear most exhaust port to the collector port is about 1/4inch longer than the original manifold. Its also wider at the collector port. To bolt it up, it would require moving the collector pipe back about 1/4 inch. No thanks. Its easier to get a used one from a junkyard.You get what you pay for.