Your cart is empty.
Your cart is empty. Item specifics
Condition:New
Part Number:STK0127
Part Type:Temperature Sensor
Model:ECS0275
ECS0275 wroks for all AquaCal Heat Pump Heaters
ECS0393 ECS0394
Use 11/32" or 3/8" drill bit to tap into water inlet line
Snug the hose clamp around the sensor
NOTE: Over tightening the hose clamp will break the sensor
Allison Cleghorn
Reviewed in the United States on March 29, 2025
Perfect, easy. My inlet water temp on pool heater reading way high when it wasn’t. This was a direct replacement and works perfectly. MAKE SURE YOU TURN OFF THE BREAKER. I took out a dozen screws on the outside panel and screws on an inside panel Saved me hundreds of $ I’m sure. 🤑 Videos ard on youtube tooThis was perfect because for my aquacal heater you have to call the manufacturer for service and I could never get through 😖
Recommended Products
