Your cart is empty.
Your cart is empty. If the remote doesn't work , please try the following troubleshoot:
1. Replace the batteries in the remote control.
2. Make sure RoboVac is turned on and fully charged;
3. If RoboVac and the remote control's display work properly, but RoboVac does not respond to the remote control's commands, it may be because the remote control has not been paired with RoboVac.
In this case, do not dock RoboVac to the Charging Base. Turn off the main power switch and then:
(1) press and hold Start/Stop button on the remote control until the "Set the current time" button (on the left of the bottom row )blinks on the display;
(2) at the same time ,turn on the main power switch.
You will hear three beeps after successful pairing.
Debkiny
Reviewed in the United States on August 6, 2024
Wrote the sender and no response to get my money back. It does not work with Bob.
Recommended Products
