Your cart is empty.
Your cart is empty.Mevotech MK80065 Alignment Camber Kit
Roger
Reviewed in the United States on July 21, 2024
Worked as promised no complaints
Jeremy
Reviewed in the United States on May 15, 2024
Worked great and great quality
Brian R.
Reviewed in the United States on August 17, 2022
Page advertises these for use on lower control arm. They are too small. I pulled the threads off the bolt trying to torque it to the spec of the upper control arm. Unsafe to use on lower.
Matthew V.
Reviewed in the United States on May 23, 2022
One kit really only does one control arm. If you lower or lift your ride you'll want two kits.
haydn
Reviewed in the United States on December 26, 2022
Ordered this when i was replacing the rebuilding the front end on 1998 firs explorer. It was a good fit.
craigp40
Reviewed in the United States on September 3, 2021
After a recent accident, I had to get my 1996 Ford Explorer XLT repaired and aligned. Never realized the front driver's side wheel didn't have a camber adjustment. Bought this kit and replaced the bolts on my upper control arm. Although the old bolts were a PITA to remove due to a little corrosion on the splined area of the bolt and limited space, these new bolts worked perfectly to allow the necessary adjustment to bring camber within spec.
Security Guy
Reviewed in the United States on October 20, 2021
Great value and quality hardware. Was finally able to align my 3” lift with mud tires Ranger at the local shop. If you don’t install this your tires will wear fast! Many thanks!
Bryan D
Reviewed in Canada on November 13, 2020
Installed as designed on my 2001 Mazda B4000 (same as Ford Ranger) 4X4. No issues and now my tires are properly aligned without excessive wear on the inner edge of the tire. This is an easy job that takes about 30 minutes per side. But you will have to get an alignment done when you're finished.
lo publicado
Reviewed in Mexico on February 18, 2019
cumple con el proposito
Susan Callow
Reviewed in the United States on August 23, 2018
Great kit! Allowed our lifted 2000 Ranger 4x4 to be able to be aligned! 3/8 ratchet holes needed to be filed (opened up) a bit to fit a ratchet.
Recommended Products
