Your cart is empty.
Your cart is empty.
feature:
1. [Technical Upgrade] MPPT wind turbine controller adopts MPPT boost charging technology to start and provide sufficient power when there is light wind and low voltage, solving the problem of poor wind turbine speed and inability to charge.
2. [Reassured Material] MPPT wind turbine controller is dustproof and waterproof (IP67), strong and wear-resistant, lightweight and temperature-resistant, bringing you the best experience. It is filled and sealed with thermally conductive material and silicone material.
3. [Safe use] The household wind turbine controller eliminates any safety risks during use. It has complete protection against overcharge, reverse connection, short circuit and high temperature, that you use it more comfortably and safely.
4. [Easy to use] The windmill generator charge controller can easily improve the efficiency and charging capacity of for the power generation . Compared with ordinary PWM charge controllers, there are no difficult steps to use.
5. [Multi-functional Design] The windmill generator charging controller is suitable for most wind turbines and has a wide range of uses. It can automatically determine and adjust the 12V and 24V voltages.
Description and features:
This wind turbine controller is a must-have when you are using a wind turbine controller at home. It might make your life more convenient.
1. Use MPPT boost charging technology to solve the problem of being unable to charge due to slow fan speed.
2. Filled and sealed with thermally conductive silicone, waterproof (IP67), dustproof, sturdy and lightweight.
3. Overcharge, reverse connection, short circuit, and high temperature protection for ENSURE safer and more convenient use.
Specification:
Name: Wind power controller
Maximum input AC voltage: AC35V
Output DC voltage: DC12V/24V
Battery charging cut-off voltage: DC14.5V±0.3V/29V±0.3V
Maximum charging current: 15A (12V) Maximum charging current: 10A (24V)
Generator speed limit voltage: DC14.5V±0.3V, 29V±0.3V
Protection level: IP67
Static power consumption: 0.008A
Bearing power: 500W/800W
Maximum bearing wind speed: lvl.12
Working temperature: -35℃-65℃
Input wiring: three-wire
Control mode: 12V/24V compatible
Installation : bolt fixed
wiring:
1. Connect the positive and negative terminals of the battery and the charging cycle respectively.
2. Connect the three-phase output voltage of the fan to the three-phase input terminal of the controller fan.
packing list:
1*Wind power controller
Precautions:
1. Confirm that the fan output voltage is consistent with the rated voltage of the battery.
2. First connect the positive and negative poles of the battery, and then connect the three-phase voltage output of the fan.
3. Please strictly follow the instructions to connect the battery and wind turbine to the controller, otherwise the controller will be damaged.
Notice:
Due to lighting effects and angles, the product may have color differences, please accept it.
There are tolerances in product dimensions due to manual measurement.
