Your cart is empty.
Your cart is empty.Product Description
Nature Bond Instructions
Pour Contents into Sprayer
Pour contents of the 1 gal Nature Bond into a pressurized sprayer.
Spray /Mix/ Spray Again
Spray onto mulch, sand, pebbles, etc. Substrate must be dry. Any moisture in the substrate will cause bond to take longer to form or no bond may occur. Best results occur when Temp is 80 degrees and higher.
Spray onto substrate, then mix so the Nature Bond can come into contact with all of the substrate, then spray again.
When spraying mulch, make sure to mix. For sand, small aggregate, no mixing is required.
Dries in 2 hours
Nature Bond has a blueish tint to show where product has been applied. Let Nature Bond dry for two hours. Bonding agent will dry clear. Product works best when temperature is above 80 deg F.
Product may take 24 hours to cure if substrate is wet/moist and/or if humidity is too high.
Clean sprayer with water
Clean sprayer by flushing with hot water immediately after use. Fill tank with hot water and spray until water comes out clear.
Remove fittings, hose and submerge in hot water for 5-10 minutes with detergent.
Clean any unwanted bonding agent by scrubbing with toothbrush or pad. Repeat step as needed.
Biofriendly & Safe for Animals
Nature Bond is safe, non-toxic, slight odor and safe for animals.
mulch
sand
straw
pebbles
David Simmons
Reviewed in the United States on May 15, 2025
Didn’t hold
A. Gift For You
Reviewed in the United States on April 20, 2025
Great product works perfectly
Pocono consumer1
Reviewed in the United States on October 26, 2024
Bought 2 different brands for stone hillside project. After applying realized 3rd gallon was needed.repurcased this as did the job and didn't clog sprayer as much as the other. Does what glue needs to do and dries clear with a little shine that it's there.
Recommended Products