Your cart is empty.
Your cart is empty.Standard Motor Products TS375T Engine Coolant Temperature Switch with Gauge
DMN
Reviewed in the United States on July 25, 2024
This part is for the gauge it fits easy to install
Kurt Pollard
Reviewed in the United States on March 31, 2024
Perfect replacement
Stephen W.
Reviewed in the United States on December 16, 2024
This is a perfect fit. Works as it should. Easy install
Christopher Hicks
Reviewed in the United States on May 11, 2023
Works very well
Doc
Reviewed in the United States on December 14, 2023
Install this without any Teflon tape or anti seize, as it requires a good connection to ground through the threads in the engine block. This restored my temperature gauge functionality before this it was reading a bit low.96 - 99 classic vortec engines have 2 temp sensors. This one is for the gauge only. The temp sensor for the computer is located on the intake.
George Grady
Reviewed in the United States on August 26, 2022
It could have had thread sealant would have been good but I had some running places not a problem
Rico
Reviewed in the United States on August 2, 2021
After checking auto parts stores I ordered this part and it was exactly what I needed.
Mike Olson
Reviewed in the United States on June 22, 2020
This sensor on the 01, 4.3l v6 controls the dash temperature gauge. If your ECM is showing a very low temp like -38 degrees, there is another temperature sensor by the thermostat. The Haynes manual incorrectly claims there is only one sensor. Before replacing any parts test with an ohm meter while heating the sensor.
Recommended Products
$13.99
$ 6 .99 $6.99