Your cart is empty.
Your cart is empty. 26mm Bore UP005 Pillow Block Bearing Features:
Made with Aluminum alloy flange base, anti-rust, durable, long service life.
This is a self-aligning pillow insert bearing that can be easily adjusted or installed.
Allows the outer ring and the inner ring to be fixed to the shaft, preventing slippage Deep groove geometry for high speed and support heavy loads.
They can also be used in machinery, conveyor systems, film processing machinery, rotating machinery, printing machinery.
Customer
Reviewed in the United States on March 31, 2024
The bearing was not 26mm. Measured with caliper at 24.85 mm
Hotroddin1971
Reviewed in the United States on March 16, 2021
Incorrect ad they are not 1" or 26mm id as stated in the ad. I needed bearings for 1" (25.4mm) shafts and the ad stated 26mm which would have been perfect. These are 25mm which do not fit 1" shafts. I ended up cutting down the1 of the shafts by .5mm to make 2 of the 4 work and this will now require a ton of work to get my sprockets to fit properly. If they would have been listed as what they actually are I never would have bought them!
dave archer
Reviewed in the United States on December 9, 2019
Not 26 mm..... close but no cigar. Might as well be a mile off.
Recommended Products
