Your cart is empty.
Your cart is empty.
Fuel tank replace # 494406 498809 498809A
Carburetor replace # 795477 795469 794147 699660 794161 498811
Air filter replace # 698369
Compatible with :
Compatible with Briggs & Stratton 9J900 9L900 9S500 9T500 9T700 Series engine
Compatible with Briggs & Stratton 09J902 09K502 09L502 09S502 09T502 09T702
Compatible with Briggs & Stratton 10D902 10L502 10T502 10T702 Engine
Used on many MTD, TORO, Murray, Poulan, Craftsman Push Lawn Mower that equipped Compatible with Briggs & Stratton engine
Package include:
1x fuel tank
1x carburetor
1x air filter
1x gasket & diaphragm
6x screws
2x primer bulb
1x spark plug
Joe
Reviewed in the United States on May 25, 2024
The carburetor fix perfectly. Mower started on second pull.
Customer
Reviewed in the United States on May 24, 2024
Carburetor kit fit exactly as expected. Much cheaper than at hardware store.
J. William Bass
Reviewed in the United States on March 13, 2024
Looked promising. Had to drill out one bolt hole that was undersized, but easily done. Installed it and engine started right up. Worked great …. for one season. Spring loaded ball valve inside pump cavity popped out and primer pump no longer works. Tried pouring a little gas in carb throat to prime. Engine started but gas started blowing out of gas cap vents, due to failed ball valve I guess.
HAM
Reviewed in the United States on December 8, 2024
Good quality, was exactly what i needed to get my edger running. Bolted up easily except for one bolt- it was a little off of alignment. Ended up putting a few zip ties through it and it’s plenty sturdy.
Mark Nazzaro
Reviewed in the United States on September 4, 2023
Installation only took 15 min. The carburetor is already attached to the tank, just needed to remove the air cleaner and two bolts.Very easy fix, my pressure washer worked on the first pull.
Edwin
Reviewed in Mexico on August 16, 2023
El tanque no lo pude instalar con las dimensiones que viene, tuve que poner el carburador en el tanque viejo, todo lo demás quedo perfecto
Braden May
Reviewed in the United States on July 16, 2023
I bought this for a pressure washer that took this size tank, carb and whatnot. Installation was a bit of trouble, having to shave a couple parts to get it to fit right but once it was together it worked great. Would let it sit for a day and try starting it for about a week just to make sure and it did fine. Then I let it sit for a little longer before using it again. The primer stopped working, I took it apart to find the plunger inside had fallen apart for the second time, the first being before installation right out of the box. I put it back together and it wouldn’t stay, the rubber piece is too small and doesn’t hold. So the primer is garbage. I can get it to start and run by putting a little gas in the carb but I’m not very happy about the primer already breaking with very little use.
Dianna B.
Reviewed in the United States on November 13, 2023
Only complaint so far is the front mounting hole on the tank. Original bolt did not fit, new tank might be metric. And had to grind the original mounting bracket to get it to line up. Didn't put enough gas in Tank yet to check for leaks
Customer
Reviewed in the United States on April 1, 2023
Have an older MTD mower. One minor issue, the bracket at the end of the tank is threaded for a metric bolt. My original was threaded 1/4-20. So I had to go buy a bolt. No big deal. Mower runs like new. Saved me from spending hundreds on another mower.
Recommended Products
