Your cart is empty.
Your cart is empty.This direct replacement harmonic balancer features a stress-resistant rubber bond to properly absorb engine vibration. Stringent standards help ensure excellent tensile and impact strength for greater durability. This part is compatible with the following vehicles. Before purchasing, enter your vehicle trim in the garage tool to confirm fitment. [Toyota Camry: 1992, 1993, 1994, 1995, 1996, 1997, 1998, 1999, 2000, 2001] - [Toyota Celica: 1994, 1995, 1996, 1997, 1998, 1999] - [Toyota RAV4: 1996, 1997, 1998, 1999, 2000] - [Toyota Solara: 1999, 2000, 2001]
Patrick
Reviewed in the United States on June 10, 2021
Like other reviewers have stated, the keyway or center hole for the balancer is too small. I could press it on with my hands about an inch or less and that's it.I was able to press it in by using the bolt and a washer and just tightened it til it was all the way down. It's working so far no issues. Only been a week and a few hundred miles but it's an easy enough job
Customer
Reviewed in the United States on November 12, 2019
Priced 30 bucks cheaper than local auto parts store but the supplied key wouldn’t fit the keyway slot in balancer. Had to file key to make it fit.
Gary
Reviewed in the United States on September 22, 2016
Shipping box was damaged & open but thankfully the parts were all there. Part worked perfictly.
Scott Hardwick
Reviewed in the United States on August 4, 2014
So far so good!
AMG98
Reviewed in the United States on July 13, 2014
Terrible quality. We bought 2 of these and the first one lasted 2 months and the second one lasted 4 months.
Jon Barnes
Reviewed in the United States on February 17, 2013
Like the another reviewer I found this pulley did not fit on the crankshaft. After close inspection I realized that the slot in the pulley that fits over the woodruff key in the crankshaft was machined too tight.I knocked out the woodruff key in my crankshaft and headed to the work bench with the key and the pulley. I used a steel file to enlarge the width of the slot in the pulley until the key fit snuggly for length of the slot. (I.E. The key would slide up and down the slot the same was it would during install.) I also sanded the bore of the pulley a small amount as well with ~300 grit sandpaper. It took me about 15mins, and I was being patient and careful.NOTE: The pulley does come with a new woodruff key, but did not fit the slot either.After the careful detailing the pulley slid on perfectly, and is working great.So, it's unfortunate that it was machined from the manufacturer incorrectly. But with a little work it is still a good deal.
moshlub
Reviewed in the United States on May 7, 2012
It's a little too tight, make it difficult to installed, but with a hammer and a support block I was able to get it installed without being damage.
Getting The Job Done
Reviewed in the United States on March 31, 2010
Bought this for a 00 Camry and when I was ready to put it on. It didn't even slide on half way and I ended up chipping some of the balancer trying to get it on.Went to Kragen/Oreilly and bought another brand that fit for about the same price. Pay a little more and avoid Dorman brand, now I'm stuck with a balancer that can't be used.
Recommended Products
$71.95
$ 34 .99 $34.99