Your cart is empty.
Your cart is empty.
Product Description:
Mechanical specifications
Size: 22.4 x 12.5 x 22.8mm
Mechanism limit angle: 200 ° ± 15 °
Output shaft: 20T, diameter: 4.9mm
Gear material: metal
Electrical characteristics
Working voltage: 4.8V-6V
No load speed: 0.11sec/60 °
No-load current: 220mA/6V
Locked rotor torque: 2.2Kg-cm/6V
Locked rotor current: 800mA ± 10%
Static current: 5mA-6mA
Control characteristics
Control signal: Pulse width modification
Control system type: Analog controller
Mid point position: 1500usec
Pulse width range: 500~2500usec
Note:
Please use a standard PWM control signal, the period is 20ms, the high level time is 0.5-2.5ms. 270 degrees and 180 degrees can stop at any angle, and the angle can be adjusted. 360 degrees is a continuous rotation, and the angle and speed cannot be controlled.
180 degrees and 270 degrees can control the angle, PWM500-2500 remote control can only have half of the stroke.
Package：
1PCS - Servo with accessories
James D.
Reviewed in the United States on May 26, 2024
Good servos, none failed and they are in fact brass geared with proper connectors and horns. Assembly is solid and they're well lubricated. Good buy.
Wills944
Reviewed in the United States on May 25, 2024
These are the standard form factor for these micro servo's and seem to be well made. I hooked them up to a nodeMCU and ran them with just a basic ino to run them through a few movements and all 4 responded great. The movements were smooth and consistent. Couldn't be happier with them!
Darren H.
Reviewed in the United States on March 31, 2024
DO NOT BUY THESE SERVOS IN ANY SIZE, they are not working properly and or consistently. lost a $400 rc plane due to these servos, after 220 flights no issues until these servos were replaced and crashed after takeoff. I installed these in the elevator of my small rc jet and replaced the oem 9g servos with more travel instead of 180 degree i wanted 270 degree. also turns out they turn 270 degree but only 70 degree one direction and 200degree other direction, so is very disappointing they serve no purpose in rc aircraft or ground vehicle. After i wiggled the servo horn they came alive again for a few movements then stopped again.
Ulli K
Reviewed in Germany on November 7, 2024
Die Servos haben genug Kraft und da sie sich um 360° drehen können umso besser
Attila Terragni
Reviewed in Italy on November 20, 2024
Nonostante le dimensioni identiche ai servo in plastica, sembrano molto più robusti.Da verificare la durata sul lungo periodo. Ma per ora sono perfetti
K-D A
Reviewed in Germany on November 13, 2024
Promte Lieferung
SOu
Reviewed in the United States on October 29, 2024
I bought these as a fill in for a sunfounder pidog project. A couple of Sunfounder motors had the shakes, Sunfounder sent new ones, but it took forever from China. So I bought these, but they all had the shakes too
Recommended Products
