Your cart is empty.
Your cart is empty.Spiral bits provide a shear cutting edge that leaves a smoother cut than standard router bits. The down cut spiral design provides the best top surface edges, ejecting chips away from the router when routing through material. This design also decreases the tendency to lift thin/small work pieces during CNC routing.
M. Newman
Reviewed in the United States on February 21, 2016
Excellent tool; 1/2" shank makes for much steadier cutting.
ray
Reviewed in the United States on October 3, 2016
everything was fine
Rojo
Reviewed in the United States on December 6, 2015
Great bit to use on a CNC. Clean cut, helps the work piece stay against the table.
Kenneth D.
Reviewed in the United States on November 10, 2015
Cost competitive carbide end mill that work sharp clean cuts.
Recommended Products
$30.98
$ 15 .99 $15.99